PLS HLP! Hytera disconnect incoming group calls or does not accept group calls

MMDVM_HS Hat hardware
Post Reply
UT3URA
Posts: 2
Joined: Mon Aug 08, 2022 7:37 am

PLS HLP! Hytera disconnect incoming group calls or does not accept group calls

Post by UT3URA »

Good afternoon. please help me, I am just learning dmr.

My hotspot is set up correctly, brandmeister is set up correctly, pai star is set up correctly!
When receiving a signal, my station constantly shows FULL antenna (I can see that the signal is 100%).

BUT it does not make a voice and don't show an incoming call (showing full antenna), or rarely takes a call for 1-2 seconds, then says "call end" and disconnects... while showing a full antenna...

The station either starts talking for 1-2 seconds and goes silent, or just goes silent, showing a full antenna...

Checking on parrot 9990 works fine
WG4USA
Posts: 22
Joined: Thu Nov 05, 2020 7:40 pm

Re: PLS HLP! Hytera disconnect incoming group calls or does not accept group calls

Post by WG4USA »

Can you get the radio into monitor mode, for both time slots?
LA3WMA
Posts: 1
Joined: Wed May 03, 2023 6:17 am

Re: PLS HLP! Hytera disconnect incoming group calls or does not accept group calls

Post by LA3WMA »

I have the same issue with my new HP785. I also have a PD785 with no problem. Both radios have the same config. The HP785 receives audio from my OpenSPOT's, but not from the MMDVM spot... And, I have two Anytone radios with no problem with the audio from MMDVM.
User avatar
YL3IM
Posts: 39
Joined: Sun Nov 22, 2020 8:38 pm
Location: Riga, Latvia
Contact:

Re: PLS HLP! Hytera disconnect incoming group calls or does not accept group calls

Post by YL3IM »

It's a known issue. For simplex channels, enable Pseudo Trunk instead of a designated slot.
Post Reply