Good afternoon,
I've seen references to this problem but not seen anything posted indicating a fix.
We installed one of the MTR2K WA0EDA boards with the Nano Pi hat and loaded with the latest image on the Pi SD card.
After turning on the Motorola MTR-2000 repeater and the Pi boots, we are able to log in and set up Pi-Star with no problems. Once we are done, the NETS of all modes we have activated are "green" but the "modes enabled" are all "red" and the "TRX" box under radio information is blank and does NOT show listening.
We do have another MTR-2000 set up with the same board and has worked flawlessly for several years. Has anyone else had this type of problem and been able to resolve it?
We've tried to re-format and re-image the SD card a couple of times with no success.
Thanks,
James Adkins, KB0NHX
MMDVM modes will not stay enabled
General support for the Pi-Star System
Return to “Pi-Star General Support”
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar