MW0MWZ wrote: ↑Fri Feb 22, 2019 12:24 am
Pi-Star AutoAP has been patched so that it no longer keeps the disk in RW mode, you will need an update and a reboot if you want to test it with the AutoAP active.
Thanks Andy !
Tested it with all my hotspots now AutoAP on and they are all running fine.
The AutoAP works as usual, and for now the "rpi-rw" and "rpi-ro" seem to function ok.
Tested it manual over SSH with PUTTY doing rpi-rw/edit a file/viewed logfile/rpi-ro.
Also tested it from Pi-Star using "update", which ended ok and made the OS "ro".
For your info here my configuration:
Hotspot #1
Hardware: raspberry pi zero-w Rev 1.1 (512 MB)
Radio: MMDVM_HS_Hat (DB9MAT & DF2ET) for PI(GPIO)
Radio Firmware: HS_Hat:v1.4.16
Description: Japanese Jumbospot-Clone
TXCO: 14.7456 MHz
Radio Frequency: 438.012500 MHz
POSCAG Frequency: n/a
OS: Linux pi-star 4.14.98+ #1200 Tue Feb 12 20:11:02 GMT 2019 armv6l
Pi-Star: 4.0.0-RC3 / Dashboard: 20190205
Enabled modes: DMR only
Auto AP: ON
uPNP: OFF
Hotspot #2
Hardware: raspberry pi zero-w Rev 1.1 (512 MB)
Radio: MMDVM_HS_Hat (DB9MAT & DF2ET) for PI(GPIO)
Radio Firmware: HS_Hat:v1.4.16
Description: Japanese Jumbospot-Clone
TXCO: 14.7456 MHz
Radio Frequency: 430.012500 MHz
POSCAG Frequency: 439.987500 MHz
OS: Linux pi-star 4.14.98+ #1200 Tue Feb 12 20:11:02 GMT 2019 armv6l
Pi-Star: 4.0.0-RC3 / Dashboard: 20190205
Enabled modes: DMR and POCSAG
Auto AP: ON
uPNP: OFF
Hotspot #3
Hardware: raspberry pi 3 Model B (1GB) - Sony, UK
Radio: DV-Mega Raspberry Pi Hat (GPIO) - Single Band (70cm)
Radio Firmware: DVMEGA HR3.19
Description: Original DVMEGA Board (using Atmel Atmega 328)
TXCO: n/a
Radio Frequency: 434.012500 MHz
POSCAG Frequency: n/a
OS: Linux pi-starb 4.14.79-v7+ #1159 SMP Sun Nov 4 17:50:20 GMT 2018 armv7l
Pi-Star: 4.0.0-RC3 / Dashboard: 20190205
Enabled modes: DMR only
Auto AP: ON
uPNP: OFF
On all my Hotspots i use a I2C OLED 0,96" monochrome or bi-color display.
73's
Adri