I ran into the issue where the only OTG cable I had has a 90 degree bend to the right that conflicted with the power input. So I had no way of connecting a keyboard and monitor to the RPi so I could access the command line.
I tried the whole auto access point and used my phone to configure it with my network settings but it refused to connect after entering the correct network details, so I was stuck with no way access this RPi and figure out what was going on.
This is the solution I came up with.
I loaded the SD card in a windows machine and edited the following two files.
open config.txt and add the following line at the end of the file
Code: Select all
open cmdline.txt and add "modules-load=dwc2,g_ether" after rootwait
Code: Select all
dwc_otg.lpm_enable=0 console=tty1 root=/dev/mmcblk0p2 rootfstype=ext4 elevator=deadline fsck.repair=yes rootwait modules-load=dwc2,g_ether quiet noswap ro
After that you simply take the RPi Zero W and insert the SD card with the changes you just made. Then plug in a normal usb Micro to A cable to the USB port on the RPi Zero W, DO NOT CONNECT ANYTHING TO THE POWER micro usb port, and then connect the other end of that USB cable into a USB port on a computer.
The computer will power up the RPi Zero W and it will begin booting. After a minute or two your computer should detect a new network device. Mine labeled it as "USB Ethernet/RNDIS Gadget"
Then all you do is open a web browser and type in "http://pi-star/" and then configure your RPi Zero as normal.
to return everything back to normal you can either insert the SD card into a computer or ssh in and edit the files back. (if you ssh in make sure you run rpi-rw)
simply insert a # in front of dtoverlay=dwc2 or remove that line and save.
and remove modules-load=dwc2,g_ether and save.
I hope someone finds this useful and interesting, I know I sure did.