forum.pistar.uk

Posted: **Wed Feb 10, 2021 2:43 pm**

Hi, I am new to this forum, but I have the same issues as you, but with one addition. When I run up Pistar-MMDVMCal it gives me the same messages as you all have, but in the menu I do not an "E/e" selection to input a frequency. I am running RPi3B with MMDVM_RPT for GPIO and 2 x GM340 radios.

As I cannot input a frequency I am unable to check any action on the input or output.

Help appreciated...

Malcolm M0MCR

Posted: **Wed Feb 10, 2021 2:55 pm**

M0MCR wrote: ↑Wed Feb 10, 2021 2:43 pm Hi, I am new to this forum, but I have the same issues as you, but with one addition. When I run up Pistar-MMDVMCal it gives me the same messages as you all have, but in the menu I do not an "E/e" selection to input a frequency. I am running RPi3B with MMDVM_RPT for GPIO and 2 x GM340 radios.

As I cannot input a frequency I am unable to check any action on the input or output.

Help appreciated...

Malcolm M0MCR

Pushed a new MMDVMCal, see if that helps.

Posted: **Fri Feb 12, 2021 3:42 pm**

Many thanks for your help I'll give it a run.

73
Malcolm
M0MCR

forum.pistar.uk

Pi-star 4.1 MMDVMCAL is broken.

Re: Pi-star 4.1 MMDVMCAL is broken.

Re: Pi-star 4.1 MMDVMCAL is broken.

Re: Pi-star 4.1 MMDVMCAL is broken.