DMR Gateway mode not working

[n9mfk]

Hi i tried 3 or 4 the only thing i notice is the number of * does not change but dmr gw it changing
is there ant way to go back to 4.15 without a backup? to see if it would help

[AF6VN]

Hi,
Here is what it shows in MMdvm.log this is from a call to parrot no audio back

For comparison, I just rebooted my system, and then insured I had 3100 active via a PTT. And to reinforce -- I am NOT using gateway modes. (Some of the DMR sub fields aren't shown as the "grep" only dumped lines with "DMR" in them -- I used that as my configuration starts both DMR and D-STAR, and I didn't want the D-Star entries).

Code: Select all

pi-star@pi-star-3b(ro):~$ grep -i "DMR" /var/log/pi-star/MMDVM-2021-12-20.log
I: 2021-12-20 23:38:13.946     DMR: enabled
I: 2021-12-20 23:38:13.946     DMR Delay: 0 (0.0ms)
I: 2021-12-20 23:38:13.946     DMR TX Level: 50.0%
I: 2021-12-20 23:38:15.985 DMR Network Parameters
M: 2021-12-20 23:38:16.266 Opening DMR Network
I: 2021-12-20 23:38:16.271 DMR Id Lookups
I: 2021-12-20 23:38:16.271     File: /usr/local/etc/DMRIds.dat
I: 2021-12-20 23:38:18.559 Loaded 208528 IDs to lookup table - /usr/local/etc/DMRIds.dat
I: 2021-12-20 23:38:18.559 Started the DMR Id lookup reload thread
I: 2021-12-20 23:38:18.559 DMR RF Parameters
I: 2021-12-20 23:38:18.559     DMR Roaming Beacons Type: off
M: 2021-12-20 23:38:28.668 DMR, Logged into the master successfully
M: 2021-12-20 23:40:11.076 DMR Slot 2, received RF voice header from AF6VN to TG 3100
M: 2021-12-20 23:40:12.696 DMR Slot 2, received RF end of voice transmission from AF6VN to TG 3100, 1.4 seconds, BER: 1.5%
pi-star@pi-star-3b(ro):~$

Note in particular, the line at time 23:38:28.668; I'd think you'd still have something like that for BM connection. I do see that there is a difference in
MINE

Code: Select all

I: 2021-12-20 23:38:15.985 DMR Network Parameters
M: 2021-12-20 23:38:16.266 Opening DMR Network
I: 2021-12-20 23:38:16.271 DMR Id Lookups

YOURS (trimmed)

Code: Select all

I: 2021-12-20 14:25:50.923 DMR Network Parameters
M: 2021-12-20 14:25:50.924 DMR, Opening DMR Network
I: 2021-12-20 14:25:50.930 DMR Id Lookups

Gateway seems to use different text for the "Opening" line.

[n9mfk]

What get me is if I pick a bm server it works fine I was going to do bm and tgif but it looks that not going to work

[n9mfk]

Hi

Here are the steps I have done

1 login in to brandmeister set hotspot password to 8 letters click save

2 login in pi-star set it to bm 3102 set password click apply it reboots

3 try parrot it works

4 go back is pi-star select DMR Gateway click apply reboots

5 enable brandmeister switch check that it on BM 3102 enter password apply it reboots

6 check dashboard dmr green dmr net green

7 3 try parrot shows trx shows dmr tx then dmr rx an dmr net goes red and no audio

[M1DNS]

Check the password is entered correctly in expert BM section, dmrgateway.

../admin/expert/edit_dmrgateway.php

Sent via smoke signals from my SM-G935F M1DNS (Admin)

[n9mfk]

Hi M1DNS,
yes is does it is under dmr network 1
what is strange is dmr netwok 2 is first in the list
any other ideas?

[n9mfk]

Hi I will try that after the holiday's thanks

[n9mfk]

Hi after a new card it works
one question under network 1

Code: Select all

TGRewrite0=2,9,2,9,1
PCRewrite0=2,94000,2,4000,1001
TypeRewrite0=2,9990,2,9990
SrcRewrite0=2,4000,2,9,1001
PassAllPC0=1
PassAllTG0=1
PassAllPC1=2
PassAllTG1=2

what does this do ?

[n9mfk]

hi as a test I just did another mew card and picked a bm network and the same code is in there
so it is part of the stock image