Callsigns not showing up.
Callsigns not showing up.
I have added another hotspot for my use. It is a RPI 0 W with an MMDVM board with OLED running 3.4.8. going to setup at clubhouse. My original one is a RPW 3 with older MMDVM (no display) running 3.4.11. works very nicely. I did the W1MSG setups on both spots. The problem is that the NEW one only occasionally displays the callsigns. The older one rarely misses. Both are setup similarly. For testing they are running concurrently, with some differences (i.e. frequencies). Anyone have any ideas? Pictures attached. (Said file too large, will try to place in another posting.)
- Attachments
-
- 01.JPG (217.6 KiB) Viewed 5034 times
Re: Callsigns not showing up.
Cont. Shows other Admin page that decode all the callsigns at similar times.
- Attachments
-
- 03.JPG (196.72 KiB) Viewed 5032 times
Re: Callsigns not showing up.
Do a manual update. I think the user db is not up to date on your pi-star
Sent from my SM-N9005 using Tapatalk
Sent from my SM-N9005 using Tapatalk
Re: Callsigns not showing up.
Did several manual updates and no luck. Swapped chips around and the problem followed the chip. So...going to reformat and reinstall since I know it is not hardware...thanks
Re: Callsigns not showing up.
Go to ADMIN page and press UPDATE. It should take about 1 minute to complete. Then turn off power to hotspot, then restore. Will take a few minutes to resume.