pistar-mmdvmcal - board not supported

DV-Mega Single / Dual band Hat for the Raspberry Pi
Post Reply
W8ADA
Posts: 1
Joined: Tue Oct 22, 2019 10:59 pm

pistar-mmdvmcal - board not supported

Post by W8ADA » Fri Nov 08, 2019 7:57 pm

I have been trying to run the "pistar-mmdvmcal" command on my RPI 3 B+ and DVMEGA dual band board to set the RxOffset and I am running into a "board not supported" error.

Am I missing something obvious; does the jumper wire need to be in place just to use "pistar-mmdvmcal" or is the DVMEGA truly not compatible with the "pistar-mmdvmcal" routine?

I am running:
Pi-Star:4.1.0-RC6
DVMEGA - HR3.26

This is the output I see from SSH:

[email protected](rw):~$ sudo pistar-mmdvmcal
Stopping Pi-Star Services...
Killing any remaining MMDVMHost processes...
MMDVMHost: no process found
MMDVMHost_NoOLED: no process found
MMDVMHost_Adafruit: no process found
Starting Calibration...
Version: 1, description: DVMEGA HR3.26
Board not supported
Starting Pi-Star Services...
Finnished...
[email protected](ro):~$


Any advice would be appreciated.

KE7FNS
Posts: 410
Joined: Wed Apr 17, 2019 11:11 pm

Re: pistar-mmdvmcal - board not supported

Post by KE7FNS » Sat Nov 09, 2019 1:55 am

The board is not supported, MMDVMCal only works with boards that run the original MMDVM firmware, or the MMDVM_HS fork.
All views, comments, posts and opinions shared are entirely my own.

Post Reply