Hi all,
Apologies if this is in the wrong section,
But I bought a 6 cavity duplexer from China (yes, I know!) that was supposedly tuned to the customer requirements. I'm seeing a VSWR of 2.5:1 on the TX. I've changed patch leads etc, and taken the duplexer out of the loop, and am seeing 1:1 between the TX and antenna.
Is it possible that it has been incorrectly tuned? I don't have the required gear to be able to test it myself. If the high SWR is down to incorrect tuning, is there anybody here that I can send it down to so that they can have a look and retune as required?
Cheers,
J
GB7GS
Duplexer Woes!
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar