forum.pistar.uk

It appears I may have bricked my Nano-Spot.
I had a problem where I was unable to load the configuration page in my chrome browser, but I could view the dashboard and Admin pages, I could also log in just fine. But the configuration page would just remain blank when I clicked on it.

I uploaded the config file I had saved on my PC, but then the screen just said:

No Mode Defined...
I don't know what mode I am in, you probaly just need to configure me.
You will be re-directed to the configuration portal in 10 secs.

After 10 seconds it would try to load the configuration page, but would just remain blank.

I rebooted the unit by unplugging the power and now all I have is are a solid green power light, and a yellow light flashing every few seconds above the power connector. no display on the screen and I am unable to access the unit through putty "serial".

Does anyone have any ideas before I toss this Nano-Spot in the round file? And yes, I have emailed Mark and left a voice mail.
No response.

Thanks All
Rob
W7NHY

My first suggestion would be

Try a different BROWSER!

My second would be to install a new copy of the Pi-Star software and start configuring from scratch -- but I don't see an SD card slot on the images of the Nano-Spot...