Page 1 of 1
OLED placing
Posted: Tue Oct 27, 2020 4:14 pm
by 2E0WHN
I know there are no dumb questions only dumb answers. But this has me a bit confused so it could be a dumb(ish) question.
With the OLED having the 4 connections there are two possible places for it to go. One is at the top where the GPIO is and the other is on the right which also has a SDA, GND ETC.
So where does the OLED go to?
This is a brain fart time for me so asking out for some help.
Re: OLED placing
Posted: Tue Oct 27, 2020 5:08 pm
by G8SEZ
It goes in the 4 connections nearest to the board edge on the GPIO connector, opposite the silk screen indicating the connections.
Pins 12, 14, 16 and 18.
Re: OLED placing
Posted: Tue Oct 27, 2020 7:41 pm
by 2E0WHN
Thanks. Top row after the 6 pins soldered to the hat.
The hat came with pre soldered adaption so the only soldering needed was for the SMA. So no chance of them touching. The first one I had got damaged by the solder iron as the pins housing melted. May have to sort with a desolder. Live and learn.
Also something else on the hat. It is not clear on the picture but there is a space at the bottom with what looks like solder tags and a set of parallel lines. I wonder what that is for. Nothing underneath as it seems to be surface mounted. Maybe for the OLED or something. Will look it up and see what it's for if I can find anything about that part of the hat.
Again, thanks for your replies.
Re: OLED placing
Posted: Sun Mar 21, 2021 3:50 pm
by G8FKL
KE7FNS wrote: ↑Tue Oct 27, 2020 7:23 pm
Make SURE the pins on the OLED do not touch the RPi's GPIO underneath. That is one of the dumbest PCB design decisions I've ever seen.
This the exact problem I have with a Chinese MMDVM board with OLED. Presumably I can simply snip off the protruding pins to clear those on the Pi Zero below?
Re: OLED placing
Posted: Sun Mar 21, 2021 4:18 pm
by G8SEZ
G8FKL wrote: ↑Sun Mar 21, 2021 3:50 pm
KE7FNS wrote: ↑Tue Oct 27, 2020 7:23 pm
Make SURE the pins on the OLED do not touch the RPi's GPIO underneath. That is one of the dumbest PCB design decisions I've ever seen.
This the exact problem I have with a Chinese MMDVM board with OLED. Presumably I can simply snip off the protruding pins to clear those on the Pi Zero below?
Yes, you only need connection to the HAT and nothing else!
Re: OLED placing
Posted: Sun Mar 21, 2021 4:22 pm
by G8FKL
Many thanks for confirming.