STM32-DVM RSSI

MMDVM_HS Hat hardware
g7kbr
Posts: 73
Joined: Thu Nov 01, 2018 1:03 pm

Re: STM32-DVM RSSI

Post by g7kbr »

K7AZ wrote:I too would like to have a procedure to obtain values to enter in the look up table.
I have access to an HP service monitor if that helps. I realize this will be a non-linear data table.
To further compound things, Repeater-Builder V3 board has a pot to adjust the RSSI voltage.

Many thanks in advance for help with this.

73
Chris K7AZ
I know this message was a while ago. But with the STM32 pi-hat, repeater builder. But how did you set the RSSI pot? Is it a voltage divider reference? I have GM350’s and connected to pin 15 for RSSI output.

Regards

Paul
G7KBR


Sent from my iPhone using Tapatalk
Post Reply