I know this message was a while ago. But with the STM32 pi-hat, repeater builder. But how did you set the RSSI pot? Is it a voltage divider reference? I have GM350’s and connected to pin 15 for RSSI output.K7AZ wrote:I too would like to have a procedure to obtain values to enter in the look up table.
I have access to an HP service monitor if that helps. I realize this will be a non-linear data table.
To further compound things, Repeater-Builder V3 board has a pot to adjust the RSSI voltage.
Many thanks in advance for help with this.
73
Chris K7AZ
Regards
Paul
G7KBR
Sent from my iPhone using Tapatalk