Page 1 of 1
4.1.4 UPDATE zumspot
Posted: Thu Feb 11, 2021 10:40 pm
by KM4UJP
I seem to have the update working a bit. I can see my self transmitting, however I am not receiving anything.
I must have some config setting wrong.
Any suggestions would be appreciated.
Re: 4.1.4 UPDATE zumspot
Posted: Thu Feb 11, 2021 11:08 pm
by G8SEZ
Need a bit more detail, can't really help without it.
Re: 4.1.4 UPDATE zumspot
Posted: Fri Feb 12, 2021 4:45 pm
by KM4UJP
I formatted the SD card with SD Card Formatter. I downloaded PiStar 4.1.4. Unzipped it.
Flashed it to the SD card with Etcher.
Created and copied wma file to SD card.
Installed card in Zumspot, after a while the WiFi saw it and I went through the config process.
When I open the Dashboard and transmit my signal shows up on the Dashboard but I am not able to receive any transmissions.
I am attaching a PDF of my config settings. Any help would be appreciated.
Well I would like to attach the config pages but this site will not accept PDF files. They are small enough to fit under the 250 limit.
Re: 4.1.4 UPDATE zumspot
Posted: Fri Feb 12, 2021 5:09 pm
by G8SEZ
KM4UJP wrote: ↑Fri Feb 12, 2021 4:45 pm
I formatted the SD card with SD Card Formatter. I downloaded PiStar 4.1.4. Unzipped it.
Flashed it to the SD card with Etcher.
Created and copied wma file to SD card.
Installed card in Zumspot, after a while the WiFi saw it and I went through the config process.
When I open the Dashboard and transmit my signal shows up on the Dashboard but I am not able to receive any transmissions.
I am attaching a PDF of my config settings. Any help would be appreciated.
Well I would like to attach the config pages but this site will not accept PDF files. They are small enough to fit under the 250 limit.
Screenshots should be attachable.
Re: 4.1.4 UPDATE zumspot
Posted: Fri Feb 12, 2021 5:11 pm
by KM4UJP
Okay, I figured it out. I did not have Hotspot security enable...forgot about that one!! Thanks