TX audio issue, RX is OK
Posted: Sat Feb 27, 2021 2:18 am
Hi everyone,
i am building a DMR Repeater with 2 CMD1550LS, and a Repeater builder MMDVM V3 board.
So far so good the repeater TX is excellent putting TG91 static and i can receive everything on my MD380.
But when i transmit with my MD380, Repeater is receiving and TX is keyed and i see myself on my RPT Pi-Star dashboard.
I also see myself on other repeater or Hotspot Dashboard when testing on TG302233. But on my XPR4580 (900) on TG302233 i do receive the DMR ID but no audio.
Transmitting with my XPR on 900 Repeater and i do received my audio on my MD380 thru the new Repeater.
On thing i dont have duplexor yet but TX is in a dummy load at Low Power and RX is in dummy load too.
Doing a test on the Parrot i got out and when the parrot answer back i get the carrier but no audio.
Here is my component testing.
With a headset with Sleeve to ground and tip as a test lead.
1. i get unsquelch noise at pin 6 of DB9,
2. then between capacitor C14 and R6 100k pot i have noise audio,
3. between capacitor C14 and R6 100k pot i have noise audio,
4. then between R6 100k pot and R10 i have noise audio,
5. then between R10 10k and C20 still have noise audio,
6. then after C20 Cap still have noise audio.
It is like if the RPT builder board is decoding the RX audio, because it does key the TX but no audio hear on other Local radio or other radio on other Repeater.
Any body have a clue of the problem?
Right now i am blocked because did too many short transmission within 60 sec. so i have to wait 1 hour before i can test again.
thanks
i am building a DMR Repeater with 2 CMD1550LS, and a Repeater builder MMDVM V3 board.
So far so good the repeater TX is excellent putting TG91 static and i can receive everything on my MD380.
But when i transmit with my MD380, Repeater is receiving and TX is keyed and i see myself on my RPT Pi-Star dashboard.
I also see myself on other repeater or Hotspot Dashboard when testing on TG302233. But on my XPR4580 (900) on TG302233 i do receive the DMR ID but no audio.
Transmitting with my XPR on 900 Repeater and i do received my audio on my MD380 thru the new Repeater.
On thing i dont have duplexor yet but TX is in a dummy load at Low Power and RX is in dummy load too.
Doing a test on the Parrot i got out and when the parrot answer back i get the carrier but no audio.
Here is my component testing.
With a headset with Sleeve to ground and tip as a test lead.
1. i get unsquelch noise at pin 6 of DB9,
2. then between capacitor C14 and R6 100k pot i have noise audio,
3. between capacitor C14 and R6 100k pot i have noise audio,
4. then between R6 100k pot and R10 i have noise audio,
5. then between R10 10k and C20 still have noise audio,
6. then after C20 Cap still have noise audio.
It is like if the RPT builder board is decoding the RX audio, because it does key the TX but no audio hear on other Local radio or other radio on other Repeater.
Any body have a clue of the problem?
Right now i am blocked because did too many short transmission within 60 sec. so i have to wait 1 hour before i can test again.
thanks