I’m setting up a recently acquired STM-32 V4 board + Rpi 3+ as a hotspot using a FT-7800.
Hotspot TX works fine on Anytone. Great audio reports both ways. BER ~ 1% I am loving the increased range using an antenna on my roof.
But -
No copy on Hytera or Moto portables.
Hytera and Moto both have essentially 0 BER on Rx.
FT-7800 set up for 9600 and Wide.
Tried repeater builder tuning instructions. Tx pot hit clicks at 35 turns CW, lost count at > 200 CCW and not hit the edge yet.
A few questions for those that might have been here before.
1. How many turns on the Tx pot end to end? Wondering if I’m getting close?
2. What am I actually adjusting? Deviation, level or offset? Guessing deviation or level but wanted to confirm. I’m assuming from what I’ve read this is a level or deviation issue and not a Offset BER issue? Does that sound right?
3. Can MMDVMCal help me here?
I have no test equipment so wondering what’s the best workflow to sort this out.
thanks
Peter
VA3YOW
STM-32 and FT-7800 sort of works
Help with other MMDVM Repeater Boards (with NO onboard RF)
Return to “Other MMDVM Modem Boards”
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar