I own and operate a D-Star repeater "KI5DLN B" in Odessa, TX. It is running Pi-Star image 4.1.4, and Update and Upgrade on 20210305. Up until recently anyone was able to link their remote Pi-Star hotspots to the repeater, myself included. I had something happen about 3 weeks ago that changed some settings in the Configuration. It could have been the winter storm we had which included rolling electricity outages (30 hours over three days). One example is that on the "Controller Software" line it changed from MMDVMHost to DStarRepeater. After getting everything in Configuration back to normal settings, I had someone tell me that they couldn't link direct to the repeater. I have looked in the "Expert" pages and can't figure anything out. If I make a change, I always change it back. I still can't link to the repeater. Any suggestions are very much appreciated.
N5MI
Mark Ingram
Linking to a Repeater
Jump to
- Pi-Star Information
- ↳ Announcements
- ↳ Feature Requests
- ↳ FAQ
- Software Support
- ↳ Pi-Star General Support
- ↳ WiFi Setup
- ↳ IP Networking
- ↳ D-Star Specific Support
- ↳ DMR Specific Support
- ↳ YSF Specific Support
- ↳ P25 Specific Support
- ↳ NXDN Specific Support
- ↳ POCSAG Specific Support
- Hardware Support
- ↳ Raspberry Pi Foundation Hardware
- ↳ Friendly Arm Nano Pi Neo / Neo Air
- ↳ Hardkernel Odroid XU3 / XU4
- ↳ Orange Pi Zero
- ↳ Nextion Screens
- ↳ OLED Screens
- ↳ ZUMSpot (Hat / Libre / USB)
- ↳ MMDVM_HS Hat(s)
- ↳ DV-Mega Hat(s)
- ↳ DV-Mega GMSK Arduino
- ↳ DVAP Dongle
- ↳ DVR-PTR V1 V2 V3
- ↳ Other MMDVM Modem Boards
- ↳ Other All-in-one Boards with included RF
- ↳ Radio Equipment
- Repeater Keepers
- ↳ Software Support
- ↳ Hardware Support
- ↳ Everything Else
- Tutorials
- ↳ W1MSG Video Tutorials
- ↳ User Submitted Video Tutorials
- ↳ Tips and Tricks
- General Conversation
- ↳ Share your stuff
- ↳ I'm new here
- ↳ CQ CQ CQ
- ↳ I need to vent
- ↳ The Bar