Issue: Enabling YSF mode Corrupts my Config file
Posted: Fri Jul 16, 2021 8:55 pm
Hello everyone!
I have my hotspot setup and working well with DMR (GD-77 radio).
I also have a FT-991A so I'd like to work Fusion/WiresX.
In pi-star I disabled DMR, saved changes, then enabled YSF, saved changes. My 991A immediately picks up RX <great!> I was able to pull up YSF rooms and made contact.
However, when visiting the config page I found I was unable to make any changes. In fact all my data was gone. Trying to access the configuration page in pi-star results in an error 'unable to read config file' or something to that effect. So it seems enabling YSF corrupts my config file.
I reset pi-star to factor settings, rebuilt the config... DMR is good, did the same steps as previous... disable DMR enable YSF... with the same result. corrupted config.
Next time, I wiped my sd card, loaded the latest version pi-star. This time, via SSH I ran sudo apt update / upgrade. Then I hit the update from the pi-star menu. I setup up DMR... all working well... disable DMR, enable YSF... and same dang thing!!!
Does anyone have any suggestions to point me in the right direction?
Thanks so much
73, KB8DIG
I have my hotspot setup and working well with DMR (GD-77 radio).
I also have a FT-991A so I'd like to work Fusion/WiresX.
In pi-star I disabled DMR, saved changes, then enabled YSF, saved changes. My 991A immediately picks up RX <great!> I was able to pull up YSF rooms and made contact.
However, when visiting the config page I found I was unable to make any changes. In fact all my data was gone. Trying to access the configuration page in pi-star results in an error 'unable to read config file' or something to that effect. So it seems enabling YSF corrupts my config file.
I reset pi-star to factor settings, rebuilt the config... DMR is good, did the same steps as previous... disable DMR enable YSF... with the same result. corrupted config.
Next time, I wiped my sd card, loaded the latest version pi-star. This time, via SSH I ran sudo apt update / upgrade. Then I hit the update from the pi-star menu. I setup up DMR... all working well... disable DMR, enable YSF... and same dang thing!!!
Does anyone have any suggestions to point me in the right direction?
Thanks so much
73, KB8DIG