STM32 repeater builder pi-hat RSSI setup
Posted: Sun Aug 08, 2021 5:29 pm
Hi all
I have a STM32 repeater builder pi-hat board on my MMDVM repeater.
I would like to setup the RSSI, but need to know how to setup the RSSI pot. If I go into MMDVMCal and run the RSSI test. I can see the figures and if I adjust the POT this figure changes.
I have my radio test setup on RX and can adjust the RX level and see change.
Can anyone help, is their a voltage I need to setup?
My radios are GM350’s and I have a feed for RSSI on pin 15.
I did look on the repeater builder website but could see any setup information. I have the version 3 board.
Regards
Paul
G7KBR
Sent from my iPhone using Tapatalk
I have a STM32 repeater builder pi-hat board on my MMDVM repeater.
I would like to setup the RSSI, but need to know how to setup the RSSI pot. If I go into MMDVMCal and run the RSSI test. I can see the figures and if I adjust the POT this figure changes.
I have my radio test setup on RX and can adjust the RX level and see change.
Can anyone help, is their a voltage I need to setup?
My radios are GM350’s and I have a feed for RSSI on pin 15.
I did look on the repeater builder website but could see any setup information. I have the version 3 board.
Regards
Paul
G7KBR
Sent from my iPhone using Tapatalk