Wires-X linking
Posted: Sat Oct 23, 2021 10:42 am
Good Morning,
I have recently upgraded to version 4.1.5 for my MMDVM repeater configured multimode repeater.
I have an HR-200 linked via RF to my repeater, In earlier versions I was able to disable the YSF in the pi-star software so all my commands would communicate the the HRI-2oo box but instead I keep calling up YSF nodes instead of Wires-X nodes
Is there a way in this version of software to turn off the YSF network so I can once again communicate with the HRI-200?
Thank You
James
I have recently upgraded to version 4.1.5 for my MMDVM repeater configured multimode repeater.
I have an HR-200 linked via RF to my repeater, In earlier versions I was able to disable the YSF in the pi-star software so all my commands would communicate the the HRI-2oo box but instead I keep calling up YSF nodes instead of Wires-X nodes
Is there a way in this version of software to turn off the YSF network so I can once again communicate with the HRI-200?
Thank You
James