forum.pistar.uk

Posted: **Wed Feb 02, 2022 8:32 pm**

Hi. My simplex Jumbo Spot has been working just fine for several months then suddenly stopped working. Network connection is fine, but not getting any traffic from the Fusion net, nor sending any out. The parrot works fine, so it seems a lot of things have to be ok, but still no cigar. Tried re-flashing the SD Card, updating the hat firmware, but no improvement. Here is my log:

Code: Select all

I: 2022-02-02 20:01:24.647 This software is for use on amateur radio networks only,
I: 2022-02-02 20:01:24.647 it is to be used for educational purposes only. Its use on
I: 2022-02-02 20:01:24.647 commercial networks is strictly prohibited.
I: 2022-02-02 20:01:24.648 Copyright(C) 2015-2020 by Jonathan Naylor, G4KLX and others
M: 2022-02-02 20:01:24.648 MMDVMHost-20210617_PS4 is starting
M: 2022-02-02 20:01:24.648 Built 16:32:57 Jun 17 2021 (GitID #9106fd6)
I: 2022-02-02 20:01:24.648 General Parameters
I: 2022-02-02 20:01:24.648     Callsign: KY4FL
I: 2022-02-02 20:01:24.648     Id: 3187650
I: 2022-02-02 20:01:24.648     Duplex: no
I: 2022-02-02 20:01:24.648     Timeout: 240s
I: 2022-02-02 20:01:24.648     D-Star: disabled
I: 2022-02-02 20:01:24.648     DMR: disabled
I: 2022-02-02 20:01:24.648     YSF: enabled
I: 2022-02-02 20:01:24.648     P25: disabled
I: 2022-02-02 20:01:24.648     NXDN: disabled
I: 2022-02-02 20:01:24.648     POCSAG: disabled
I: 2022-02-02 20:01:24.648     FM: disabled
I: 2022-02-02 20:01:24.648 Modem Parameters
I: 2022-02-02 20:01:24.648     Port: /dev/ttyAMA0
I: 2022-02-02 20:01:24.648     Protocol: uart
I: 2022-02-02 20:01:24.648     RX Invert: no
I: 2022-02-02 20:01:24.648     TX Invert: yes
I: 2022-02-02 20:01:24.648     PTT Invert: no
I: 2022-02-02 20:01:24.648     TX Delay: 100ms
I: 2022-02-02 20:01:24.648     RX Offset: 0Hz
I: 2022-02-02 20:01:24.648     TX Offset: 0Hz
I: 2022-02-02 20:01:24.648     RX DC Offset: 0
I: 2022-02-02 20:01:24.649     TX DC Offset: 0
I: 2022-02-02 20:01:24.649     RF Level: 100.0%
I: 2022-02-02 20:01:24.649     DMR Delay: 0 (0.0ms)
I: 2022-02-02 20:01:24.649     RX Level: 50.0%
I: 2022-02-02 20:01:24.649     CW Id TX Level: 50.0%
I: 2022-02-02 20:01:24.649     D-Star TX Level: 50.0%
I: 2022-02-02 20:01:24.649     DMR TX Level: 50.0%
I: 2022-02-02 20:01:24.649     YSF TX Level: 50.0%
I: 2022-02-02 20:01:24.649     P25 TX Level: 50.0%
I: 2022-02-02 20:01:24.649     NXDN TX Level: 50.0%
I: 2022-02-02 20:01:24.649     POCSAG TX Level: 50.0%
I: 2022-02-02 20:01:24.649     FM TX Level: 50.0%
I: 2022-02-02 20:01:24.649     TX Frequency: 438800000Hz (438800000Hz)
I: 2022-02-02 20:01:24.649     Use COS as Lockout: no
M: 2022-02-02 20:01:24.650 Opening the MMDVM
I: 2022-02-02 20:01:26.661 MMDVM protocol version: 1, description: MMDVM_HS_Hat-v1.5.2 20201108 14.7456MHz ADF7021 FW by CA6JAU GitID #89daa20
I: 2022-02-02 20:01:26.681 Display Parameters
I: 2022-02-02 20:01:26.682     Type: OLED
I: 2022-02-02 20:01:27.063 System Fusion Network Parameters
I: 2022-02-02 20:01:27.063     Local Address: 127.0.0.1
I: 2022-02-02 20:01:27.063     Local Port: 3200
I: 2022-02-02 20:01:27.063     Gateway Address: 127.0.0.1
I: 2022-02-02 20:01:27.063     Gateway Port: 4200
I: 2022-02-02 20:01:27.063     Mode Hang: 20s
M: 2022-02-02 20:01:27.063 Opening YSF network connection
I: 2022-02-02 20:01:27.064 Opening UDP port on 3200
I: 2022-02-02 20:01:27.064 RSSI
I: 2022-02-02 20:01:27.064     Mapping File: /usr/local/etc/RSSI.dat
I: 2022-02-02 20:01:27.064 Loaded 14 RSSI data mapping points from /usr/local/etc/RSSI.dat
I: 2022-02-02 20:01:27.065 YSF RF Parameters
I: 2022-02-02 20:01:27.065     Low Deviation: no
I: 2022-02-02 20:01:27.065     Remote Gateway: no
I: 2022-02-02 20:01:27.065     TX Hang: 4s
I: 2022-02-02 20:01:27.065     Self Only: no
I: 2022-02-02 20:01:27.065     Mode Hang: 20s
I: 2022-02-02 20:01:27.189 Interfaces Info
I: 2022-02-02 20:01:27.190     IPv4: lo:127.0.0.1
I: 2022-02-02 20:01:27.190     IPv4: wlan0:192.168.1.220
I: 2022-02-02 20:01:27.190     Default interface is : wlan0
I: 2022-02-02 20:01:27.190     IP to show: wlan0:192.168.1.220
M: 2022-02-02 20:01:27.191 MMDVMHost-20210617_PS4 is running

Posted: **Wed Feb 02, 2022 11:40 pm**

No, also cant see anything obvs. that looks adrift in the log extract.

Can you link to other YSF reflectors or FCS rooms?

What or to where were you connecting?

Obvs. not to america link itself as they are hosted on wires x network. What bridge or bridged reflector are you trying to link with. The issue with some of these larger cross linked groups is many of the bridges are ran by 3rd parties with their bridges hosted on home connections. Its a littery of tunnels ysf, fcs, yfcs, pysf. if one goes amiss it doesnt hurt am/link but it's just dropped your path into them.

Sent via smoke signals from my SM-G935F M1DNS (Admin)

Posted: **Thu Feb 03, 2022 3:27 pm**

Hi KE7FNS and M1DNS,

Thank you for taking the time to look into my issue. After reading your messages this morning, I fired up the hot spot and began the process of capturing the log with a connection to the YSF Parrot, and then to America Link, hoping that would show something useful. The link to the Parrot worked just fine, same as yesterday. I then linked to America Link, sent out a message asking for a radio check, and very unfortunately, it worked - I got an immediate response. Being an engineer with 40 years of experience, I can truly say "I hate when that happens". Now I don't know if I have a flaky unit, or somehow a sequence of operations cleared up a problem, or what. Best I can do now is backup the configuration, take screen shots of the setup, and keep my fingers crossed!

Thanks again for your time, much appreciated!
73's
KY4FL (Paul in NC, USA)

forum.pistar.uk

Can Link to YSF Parrot, But Not America Link

Can Link to YSF Parrot, But Not America Link

Re: Can Link to YSF Parrot, But Not America Link

Re: Can Link to YSF Parrot, But Not America Link