forum.pistar.uk

Good afternoon. please help me, I am just learning dmr.

My hotspot is set up correctly, brandmeister is set up correctly, pai star is set up correctly!
When receiving a signal, my station constantly shows FULL antenna (I can see that the signal is 100%).

BUT it does not make a voice and don't show an incoming call (showing full antenna), or rarely takes a call for 1-2 seconds, then says "call end" and disconnects... while showing a full antenna...

The station either starts talking for 1-2 seconds and goes silent, or just goes silent, showing a full antenna...

Checking on parrot 9990 works fine

Can you get the radio into monitor mode, for both time slots?

I have the same issue with my new HP785. I also have a PD785 with no problem. Both radios have the same config. The HP785 receives audio from my OpenSPOT's, but not from the MMDVM spot... And, I have two Anytone radios with no problem with the audio from MMDVM.

It's a known issue. For simplex channels, enable Pseudo Trunk instead of a designated slot.