Page 1 of 1
Dstar and DMR
Posted: Wed Feb 01, 2023 8:07 pm
by ki4ehn
This may have been asked before and if it has I am sorry for the double post.
I have a dual band duplex hotspot and would like to know if I can run Dstar and DMR at the same time.
I know they will have to be on different frequencies but will it work?
73
Re: Dstar and DMR
Posted: Wed Feb 01, 2023 8:40 pm
by AF6VN
Clarify:
Dual-band usually means a board that can operate on 2m OR 70cm, but not both at the same time
Duplex is taken to mean the board operates as a REPEATER, rather than the common simplex hot-spot. Repeater boards can typically support both DMR TS1 and TS2 at the same time, but are limited to a single band (no cross-band repeating).
Re: Dstar and DMR
Posted: Thu Feb 02, 2023 7:29 am
by M1DNS
Whilst you can run any/ all modes at any one time youll only ever have one active mode thats in use, either tx'ing or rx ing.
You can only set one freq. (simplex or split) in pistar for ur hotspot. *
Sent via smoke signals from my SM-G935F M1DNS (Admin)