Just upgraded to .7 but was doing this on .6 as well
If you use the YSF Link Manager to Link 00002 YSF2DRM then use the Manager to Unlink it goes into an Unlink loop constantly announcing on the radio.
Config is set with Startup Host: None and DMR TG 4000 (Disconnect)
Using the Mic key * works fine
Unlink Loop using Link Manager
Re: Unlink Loop using Link Manager
.7 solves a back end OS issue which fixes expired update keys.
Its not going to or shouldnt be expected to fix issues you have with ur current installation.
You can usually keep up with the chages by reading the change log section at the bottom of the pistar downloads page.
. -------------------------
Ive tried to emulate ur problem, linking /unlink using both keypad/ wires x button and the link manager and im not seeing the same.
currently as i can see ur the only one seeing this behaviour. Thats not me being dismissive, but if others report the same...
Sent via smoke signals using my SM-G935F
Its not going to or shouldnt be expected to fix issues you have with ur current installation.
You can usually keep up with the chages by reading the change log section at the bottom of the pistar downloads page.
. -------------------------
Ive tried to emulate ur problem, linking /unlink using both keypad/ wires x button and the link manager and im not seeing the same.
currently as i can see ur the only one seeing this behaviour. Thats not me being dismissive, but if others report the same...
Sent via smoke signals using my SM-G935F
Andrew M1DNS.
Pi-star Admin Team.
Pi-star Admin Team.
Re: Unlink Loop using Link Manager
Wasn't expecting .7 to fix the issue, just stating it exists in both versions.
I tried to remove the 4000 from DMR TG in Fusion Config but it keeps coming back.
And every time I make a change to Config and Apply it sets System Fusion and System Fusion Network back to zero and I have to go into expert and change it manually back to 1.
I tried to remove the 4000 from DMR TG in Fusion Config but it keeps coming back.
And every time I make a change to Config and Apply it sets System Fusion and System Fusion Network back to zero and I have to go into expert and change it manually back to 1.