Brandmeister TG4000 Not Acknowledge
Brandmeister TG4000 Not Acknowledge
I am using an Anytone D878UV v1.23 firmware and CPS software. I have TG4000 (All Call), slot 1, programmed into a separate zone. When I PTT to disconnect, there is no unlinked announcement and the conversation I just finished is not disconnected. When I check Brandmeister activity, the TG is listed and then execute "Drop Call", the TG still does not disconnect. I am using Brandmeister master 3103. I have programmed many radios but this problem I have never encountered. I am suspect that it is a firmware issue. Your thoughts would be appreciated.