Page 1 of 1
STM32-DVM V3 Kenwood tm710g help
Posted: Tue Jun 12, 2018 1:33 am
by KB1ZBT
Greetings just trying to set up my device recently got a STM32-DVM V3 and I can't seem to get it setup right. Something is not decoding the digital so I just get digital garbled noise. Tried the tx rx settings in expert can't say I know what I'm doing just thought someone could simplify it all for me thanks
KB1ZBT
Re: STM32-DVM V3 Kenwood tm710g help
Posted: Tue Jun 12, 2018 1:43 am
by N6MIK
I had the same problem with my STM32 using Yaesu Radios...
Keep in mind that the tx/rx offsets in the pi-star settings don't do anything when you're connected to an external radio.... make sure that your tx deviation and frequency of the radio are good, and work the TX_G pot until you dial it in.
Re: STM32-DVM V3 Kenwood tm710g help
Posted: Tue Jun 12, 2018 1:16 pm
by KB1ZBT
Tried this to no avail I am sure there is some simple thing I am missing like a radio setting or such. Any other advice would be welcome. Thanks
Re: STM32-DVM V3 Kenwood tm710g help
Posted: Tue Jun 12, 2018 2:17 pm
by N6MIK
Set your radio for wideband (vs. narrow, if you have that choice), and 9600bps data. Also play with the TX Invert setting in Pi-Star's MMDVMHost settings...
Re: STM32-DVM V3 Kenwood tm710g help
Posted: Fri Jun 15, 2018 3:32 pm
by KB1ZBT
Got it thanks
Re: STM32-DVM V3 Kenwood tm710g help
Posted: Mon Jun 18, 2018 2:34 am
by KB1ZBT
Really strange was working now back to no decoding tried toggling all the suggested setting but can't get it to work???