forum.pistar.uk

Good Morning all,

I am trying to use my FTM200D with my Zumspot.

I tested the settings for DMR with a DMR radio and it works fine.

When I try to use the YSF2DMR feature it will connect to YSF2DMR but when I enter the TG # it will not connect. The same thing is happening when I use my FT70D.

Settings:

Yaesu System Fusion Configuration
Setting Value
YSF Startup Host: None
UPPERCASE Hostfiles: ON
WiresX Passthrough: ON

(YSF2DMR)CCS7/DMR ID: my number
DMR Master: set to US
Hotspot Security: PW
DMR TG: 4000


Any suggestions? MY power is set to low tx

Out of interest what version of Pi-Star are you using - I have worked with Jonathan to fix up some issues in YSFGateway recently, those changes are only available in 4.3.x (once you get to this point, you will no longer need Uppercase host files any more).

I used my Yaesu radio, dialed #00002 for YSF2DMR, and then once it connected, dialled #00091 and imediately started getting traffic from TG91.

The only difference with my config, is I have my DMR TG set to 9, so that I need to manually dial a TG when I want one.

Hope that helps

Hello Andy,

I am using 4.1.10 Just updated this am.

Thank you for your help