forum.pistar.uk

After much fooling around yesterday I was able to get into the Pi-star dashboard. Then I put in the USID and PW, pi-star, raspberry and got into config

I changed the data to my call sign but was careful not to change the PW.

Since that one time the Dashboard will not accept the U/TXSID and PW.

Does anyone have any idea what to do?

I am about to put this thing up on eBay.

I can see the two little green lights flashing between DMR and D-Star which were my choices.

I changed the RX/TX freq to 433.450, which is an unused simples freq on my TYT-390.

When I key up the radio the little green lights stop flashing and stay on DMR for a while.

I have never heard any audio back, which makes me think I have some config wrong. But not being able to get in and fiddle around to try to diagnose the problem is making me insane.

Any help would be appreciated.

I changed the data to my call sign but was careful not to change the PW.

Where exactly did you change the data to your call sign?

• The user name for signing into Pi-Star Admin is always pi-star. At this time, the user name can't be changed.
• The password used for signing into Pi-Star Admin (by default, raspberry) depends on what you enter in the Remote Access Password section. You can change this password.
• The URL for accessing Pi-Star via a browser uses the Hostname (by default, pi-star: http://pi-star/ for Windows and http://pi-star.local/ for macOS etc.). You can change the Hostname in the General Configuration section.

People who run multiple hotspots change the Hostname in order to be able to access a specific hotspot. For example, I have a hotspot base unit (Hostname = pi-star-base) and a hotspot mobile unit (Hostname = pi-star-mobile). So when I access Pi-Star via my Mac browser, I use http://pi-star-base.local/ for the base unit, or http://pi-star-mobile.local/ for the mobile unit. But in both cases, when I want to then access Pi-Star Admin (including the Configuration page), the user name is still pi-star.

I reformatted the SD card and re-etched it. Made a new wpa_ file and now I can connect to the Zumspot.