IPv6/4.1.0 RC 4/Wired Ethernet
Posted: Thu Aug 29, 2019 11:02 pm
I'm having an odd issue on my Pi-Star 4.1.0 RC4 system which is using wired ethernet.
I'm not getting a global IP address from my IPv6 DHCP server on boot.
Aug 29 18:29:04 pi-star dhcpcd[211]: eth0: soliciting an IPv6 router
Aug 29 18:29:04 pi-star dhcpcd[211]: ipv6nd_startrs1: Address family not supported
Aug 29 18:29:04 pi-star dhcpcd[211]: ipv6nd_startrs1: Address family not supported
After the system is up, if I rerun dhcpcd (systemctl restart dhcpcd.service) I then get the expected IPv6 global address from DHCP.
Aug 29 18:58:30 pi-star systemd[1]: Started dhcpcd on all interfaces.
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: ADV 2001:xxx:xxxx:34/128 from fe80::xxxx:xxxx:xxxx:xxxx
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: accepted reconfigure key
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: REPLY6 received from fe80::xxxx:xxxx:xxxx:xxxx
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: adding address 2001:xxx:xxxx:34/128
Can someone else please replicate this (on a wired ethernet system)? I had it working just fine with the 4.0.0 RC4 build. I also have another wired ethernet system running Buster (an upgrade from Stretch) where IPv6 gets the proper address at bootup.
73
I'm not getting a global IP address from my IPv6 DHCP server on boot.
Aug 29 18:29:04 pi-star dhcpcd[211]: eth0: soliciting an IPv6 router
Aug 29 18:29:04 pi-star dhcpcd[211]: ipv6nd_startrs1: Address family not supported
Aug 29 18:29:04 pi-star dhcpcd[211]: ipv6nd_startrs1: Address family not supported
After the system is up, if I rerun dhcpcd (systemctl restart dhcpcd.service) I then get the expected IPv6 global address from DHCP.
Aug 29 18:58:30 pi-star systemd[1]: Started dhcpcd on all interfaces.
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: ADV 2001:xxx:xxxx:34/128 from fe80::xxxx:xxxx:xxxx:xxxx
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: accepted reconfigure key
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: REPLY6 received from fe80::xxxx:xxxx:xxxx:xxxx
Aug 29 18:58:31 pi-star dhcpcd[1099]: eth0: adding address 2001:xxx:xxxx:34/128
Can someone else please replicate this (on a wired ethernet system)? I had it working just fine with the 4.0.0 RC4 build. I also have another wired ethernet system running Buster (an upgrade from Stretch) where IPv6 gets the proper address at bootup.
73