Upgrade Nag Screen not showing for DstarRepeater

[G1KEA]

I run two gateways a 2m D-Star with DV-Mega Modem and a 70cm D-Star / DMR with Zum Radio board. Both were running 4.1.2 the MMDVM config displayed the Upgrade banner across the top but the DstarRepeater config did not. So far I've updated the MMDVM config and no issues at all, will now go and do the other upgrade.

[M1DNS]

If your running a dstarrepeater pistar setup the changes seen are not going to benefit you that much. Most all changes is happening in the other modes / networks.

Apart from the obvs. dashboard updates that you might benefit from and the new release recently of ircddbgateway, and upcoming changes with aprsgateway, your running a software that is dated but needs to stay that way for your choice in using legacy hardware. So the nagg screen prob. isnt justified in this case



Sent from my SM-G935F using Tapatalk

[G1KEA]

Thanks Andrew, just thought I'd mention it.

[M1DNS]

Thanks Andrew, just thought I'd mention it.

Sent from my SM-G935F using Tapatalk

[MW0MWZ]

I run two gateways a 2m D-Star with DV-Mega Modem and a 70cm D-Star / DMR with Zum Radio board. Both were running 4.1.2 the MMDVM config displayed the Upgrade banner across the top but the DstarRepeater config did not. So far I've updated the MMDVM config and no issues at all, will now go and do the other upgrade.

They both run the same code for the config page, so long as they are updated (so that the banner code actually arrives) then they will show it.