4.1.4 UPDATE zumspot

[KM4UJP]

I seem to have the update working a bit. I can see my self transmitting, however I am not receiving anything.

I must have some config setting wrong.

Any suggestions would be appreciated.

[G8SEZ]

Need a bit more detail, can't really help without it.

[KM4UJP]

I formatted the SD card with SD Card Formatter. I downloaded PiStar 4.1.4. Unzipped it.
Flashed it to the SD card with Etcher.
Created and copied wma file to SD card.

Installed card in Zumspot, after a while the WiFi saw it and I went through the config process.

When I open the Dashboard and transmit my signal shows up on the Dashboard but I am not able to receive any transmissions.

I am attaching a PDF of my config settings. Any help would be appreciated.

Well I would like to attach the config pages but this site will not accept PDF files. They are small enough to fit under the 250 limit.

[G8SEZ]

I formatted the SD card with SD Card Formatter. I downloaded PiStar 4.1.4. Unzipped it.
Flashed it to the SD card with Etcher.
Created and copied wma file to SD card.

Installed card in Zumspot, after a while the WiFi saw it and I went through the config process.

When I open the Dashboard and transmit my signal shows up on the Dashboard but I am not able to receive any transmissions.

I am attaching a PDF of my config settings. Any help would be appreciated.

Well I would like to attach the config pages but this site will not accept PDF files. They are small enough to fit under the 250 limit.

Screenshots should be attachable.

[KM4UJP]

Okay, I figured it out. I did not have Hotspot security enable...forgot about that one!! Thanks