Nextion display on Orange Pi Zero

[ON5CT]

Hello everyone

Is it possible to connect a Nextion display to an ORANGE PI ZERO
if so which pin layout should I use ?
thanks in advance !!!

Dirk ON5CT SYSOP: ON0SNW and ON0WL

[MW0MWZ]

I dont see why not - the GPIO is much the same as the raspberry pi (although for reasons that I dont understand Orange Pi seems to be inverted....)
The UART is there to drive a Nextion so the PIN to PIN connections are the same, the placement of the pins is just not quite the same on that board.

Hope that makes some sense.