Dstar Setup

[N9DU]

I am unsure what I am doing wrong. I can listen to different reflectors on my hotspot, but I can't seem to transmit to them. I apologize in advance as I am not that computer-smart. More mechanical. I am unsure how to add a picture of the settings, so I copied and pasted it. Also, I am registered in the Dstar registry as WI9VLB, but when I upgraded to extra, I got a new call, N9DU. So not sure that is screwing things up, but I did place my hotspot as public. I have a 9700 for my base rig at home. Any help would be greatly appreciated.

Pi-Star Digital Voice - Configuration
Dashboard | Admin | Expert | Calibrate | Power | Update | Backup/Restore | Factory Reset

Gateway Hardware Information
Hostname Kernel Platform CPU Load CPU Temp
pi-star 5.10.103-v7+ Raspberry Pi 2 Model B Rev 1.1 0.14 / 0.06 / 0.06 45.5°C / 113.9°F

Control Software
Setting Value
Controller Software: DStarRepeater MMDVMHost (DV-Mega Minimum Firmware 3.07 Required)
Controller Mode: Simplex Node Duplex Repeater (or Half-Duplex on Hotspots)


MMDVMHost Configuration
Setting Value
DMR Mode:
DMR Mode
RF Hangtime:
20
Net Hangtime:
20
D-Star Mode:
DStar Mode
RF Hangtime:
20
Net Hangtime:
20
M17 Mode:
M 17 Mode
RF Hangtime:
20
Net Hangtime:
20
YSF Mode:
Y S F Mode
RF Hangtime:
20
Net Hangtime:
20
P25 Mode:
P 25 Mode
RF Hangtime:
20
Net Hangtime:
20
NXDN Mode:
NXDN Mode
RF Hangtime:
20
Net Hangtime:
20
YSF2DMR:
Y S F 2 DMR Mode
YSF2NXDN:
Y S F 2 NXDN Mode
YSF2P25:
Y S F 2 P 25 Mode
DMR2YSF:
DMR 2 Y S F Mode
Uses 7 prefix on DMRGateway
DMR2NXDN:
DMR 2 NXDN Mode
Uses 7 prefix on DMRGateway
POCSAG:
POCSAG Mode
POCSAG Paging Features
MMDVM Display Type:
OLED Type 3
Port:
/dev/ttyAMA0
Nextion Layout:
G4KLX


General Configuration
Setting Value
Hostname:
pi-star
Do not add suffixes such as .local
Node Callsign:
WI9VLB
Radio Frequency:
433.550000
MHz
Latitude:
44.156972
degrees (positive value for North, negative for South)
Longitude:
-88.46907
degrees (positive value for East, negative for West)
Town:
Neenah, Wisconsin
Country:
United States
URL:
https://www.qrz.com/db/n9du
Auto Manual
Radio/Modem Type:
Node Type: Private Public
APRS Host Enable:
Enable APRS Position Reporting
APRS Host:
noam.aprs2.net
System Time Zone:
Dashboard Language:
english_us


D-Star Configuration
Setting Value
RPT1 Callsign: WI9VLB
B
RPT2 Callsign: WI9VLB G
Remote Password:
•••••••••
Default Reflector:
REF019

B
Startup Manual
ircDDBGateway Language:
English_(US)
Time Announcements:
D-Star Time Announcements
Callsign Routing:
Enable ircDDB callsign routing
Connect ircDDB for call routing
Use DPlus for XRF:
Use D-Plus for XRF Hosts
Note: Update Required if changed


Mobile GPS Configuration
Setting Value
MobileGPS Enable:
Mobile GPS
GPS Port:
/dev/ttyACM0
GPS Port Speed:
38400


Firewall Configuration
Setting Value
Dashboard Access: Private Public
ircDDBGateway Remote: Private Public
SSH Access: Private Public
Auto AP: On Off Note: Reboot Required if changed
uPNP: On Off

[M1DNS]

Have you read the FAQ section of this Forum?

Sent via smoke signals using my SM-G935F