If I do the upgrade to 4.2.2, Can I use a configuration saved from 4.1.8

[N7KLT]

Yes I am new to the forum so, I am sorry if I didn't find this topic if already posted elsewhere. I did look.

I have a Bridgecom SkyBridge Plus (old version NOT the new Max version) that I have had for a few years. It was down as it got corrupted and I couldn't get it back up and running until recently (it was down for over 14 months).

I got it back up and running and did the "upgrade" and update through the GUI. I have saved the current configuration also because I had to use an older version that I had downloaded and a saved configuration to get it working again.

I'm interested in doing the upgrade to 4.2.2 BUT with it being a different base OS, will I still be able to upload the current configuration save for all of the settings through the GUI?

I have seen comments about putting the config in a specific folder on the card somehow but, I'm not deep into code writing and don't want to mess it up.

Any and all help is greatly appreciated, Thank you!

N7KLT

[MW0MWZ]

Short version - yes.
Longer version, image onto a new card, you can always go back to the old card if you need to dig out some setting that did not come over.

[N7KLT]

Thank you for the answer!
I thought that was the case but didn't want to "assume" and mess everything up!

Dale
N7KLT